toshi:~ # dmesg Linux version 2.4.0-4GB (root@Pentium.suse.de) (gcc version 2.95.2 19991024 (release)) #1 Wed Jan 24 15:55:09 GMT 2001 BIOS-provided physical RAM map: BIOS-e820: 000000000009fc00 @ 0000000000000000 (usable) BIOS-e820: 0000000000000400 @ 000000000009fc00 (reserved) BIOS-e820: 000000000000e800 @ 00000000000e0000 (reserved) BIOS-e820: 0000000000000600 @ 00000000000ee800 (reserved) BIOS-e820: 0000000000000200 @ 00000000000eee00 (ACPI NVS) BIOS-e820: 0000000000001000 @ 00000000000ef000 (reserved) BIOS-e820: 0000000000010000 @ 00000000000f0000 (reserved) BIOS-e820: 000000000eef0000 @ 0000000000100000 (usable) BIOS-e820: 0000000000010000 @ 000000000eff0000 (ACPI data) BIOS-e820: 0000000001000000 @ 000000000f000000 (reserved) BIOS-e820: 0000000000080000 @ 00000000fff80000 (reserved) On node 0 totalpages: 61424 zone(0): 4096 pages. zone(1): 57328 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=Linux_2.4 ro root=306 BOOT_FILE=/boot/vmlinuz_24 BOOT_FILE=/boot/vmlinuz_24 Initializing CPU#0 Detected 1095.536 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 2182.34 BogoMIPS Memory: 238388k/245696k available (1412k kernel code, 6920k reserved, 560k data, 108k init, 0k highmem) Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 256K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000 CPU: Common caps: 0383f9ff 00000000 00000000 00000000 CPU: Intel Pentium III (Coppermine) stepping 0a Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.37 (20001109) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfe34a, last bus=5 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent Unknown bridge resource 2: assuming transparent PCI: Using IRQ router ALI [10b9/1533] at 00:07.0 PCI: Found IRQ 11 for device 00:06.0 PCI: Found IRQ 11 for device 00:11.0 PCI: Found IRQ 11 for device 00:11.1 got res[1000:10ff] for resource 0 of PCI device 10b9:5451 got res[10000000:10000fff] for resource 1 of PCI device 10b9:5451 got res[10001000:10001fff] for resource 0 of PCI device 1179:0617 got res[10002000:10002fff] for resource 0 of PCI device 1179:0617 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket DMI 2.3 present. 45 structures occupying 1487 bytes. DMI table at 0x000EC000. BIOS Vendor: TOSHIBA BIOS Version: Version 1.10 BIOS Release: 09/13/2001 System Vendor: TOSHIBA. Product Name: Satellite 1805. Version PS183U-00JRSX. Serial Number Y1097153P,PS183U-00JRSX,PMSI3U34XPR1TACT/SQ002035A83. Board Vendor: TOSHIBA. Board Name: Portable PC. Board Version: Version A0. Asset Tag: 0000000000. apm: BIOS version 1.2 Flags 0x02 (Driver version 1.14) Starting kswapd v1.8 vesafb: framebuffer at 0xfc000000, mapped to 0xcf800000, size 16384k vesafb: mode is 1024x768x16, linelength=2048, pages=9 vesafb: protected mode interface info at c000:77f8 vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 128x48 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured block: queued sectors max/low 158314kB/27242kB, 512 slots per queue RAMDISK driver initialized: 16 RAM disks of 64000K size 1024 blocksize loop: enabling 8 loop devices Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ALI15X3: IDE controller on PCI bus 00 dev 20 PCI: No IRQ known for interrupt pin A of device 00:04.0. Please try using pci=biosirq. ALI15X3: chipset revision 195 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xeff0-0xeff7, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xeff8-0xefff, BIOS settings: hdc:DMA, hdd:pio hda: HITACHI_DK23CA-20, ATA DISK drive ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx hdc: TOSHIBA DVD-ROM SD-R2102, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 39070080 sectors (20004 MB) w/2048KiB Cache, CHS=2432/255/63, UDMA(33) hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 < hda5 hda6 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 LVM version 0.9 by Heinz Mauelshagen (13/11/2000) lvm -- Driver successfully initialized RAMDISK: Compressed image found at block 0 Uncompressing...............................................................................done. Freeing initrd memory: 463k freed Serial driver version 5.02 (2000-08-09) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A Real Time Clock Driver v1.10d SCSI subsystem driver Revision: 1.00 3w-xxxx: tw_findcards(): No cards found. request_module[scsi_hostadapter]: Root fs not mounted request_module[scsi_hostadapter]: Root fs not mounted request_module[scsi_hostadapter]: Root fs not mounted linear personality registered raid0 personality registered raid1 personality registered raid5 personality registered raid5: measuring checksumming speed 8regs : 1815.200 MB/sec 32regs : 1370.800 MB/sec pIII_sse : 2222.400 MB/sec pII_mmx : 2479.200 MB/sec p5_mmx : 2584.800 MB/sec raid5: using function: pIII_sse (2222.400 MB/sec) md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md.c: sizeof(mdp_super_t) = 4096 autodetecting RAID arrays autorun ... ... autorun DONE. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) IP-Config: No network devices available. NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem). usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Found IRQ 11 for device 00:02.0 usb-ohci.c: USB OHCI at membase 0xd0813000, IRQ 11 usb-ohci.c: usb-00:02.0, PCI device 10b9:5237 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver hid mice: PS/2 mouse device common for all mice fatfs: bogus cluster size fatfs: bogus cluster size hub.c: USB new device connect on bus1/2, assigned device number 2 mouse0: PS/2 mouse device for input0 input0: USB HID v1.00 Mouse [Cypress Sem. USB Mouse] on usb1:2.0 reiserfs: checking transaction log (device 03:06) ... Warning, log replay starting on readonly filesystem reiserfs: replayed 63 transactions in 11 seconds Using r5 hash to sort names reiserfs: using 3.5.x disk format ReiserFS version 3.6.25 VFS: Mounted root (reiserfs filesystem) readonly. change_root: old root has d_count=3 Trying to unmount old root ... okay Freeing unused kernel memory: 108k freed Adding Swap: 136512k swap-space (priority -1) eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html eepro100.c: $Revision: 1.35 $ 2000/11/17 Modified by Andrey V. Savochkin and others PCI: Found IRQ 11 for device 00:0a.0 eth0: OEM i82557/i82558 10/100 Ethernet, 00:00:39:C6:74:85, IRQ 11. Receiver lock-up bug exists -- enabling work-around. Board assembly 000000-000, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0xb874c1d3). Linux PCMCIA Card Services 3.1.22 kernel build: 2.4.0-4GB #1 Wed Jan 24 15:55:09 GMT 2001 options: [pci] [cardbus] [apm] Intel PCIC probe: PCI: Found IRQ 11 for device 00:11.0 PCI: Found IRQ 11 for device 00:11.1 Toshiba ToPIC100 rev 32 PCI-to-CardBus at slot 00:11, mem 0x10001000 host opts [0]: [slot 0xf0] [ccr 0x10] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 3/3] host opts [1]: [slot 0xf0] [ccr 0x20] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 4/4] ISA irqs (default) = 3,4,5,7,9,10,12 PCI status changes cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0800-0x08ff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x408-0x40f 0x480-0x48f 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. eth0: 0 multicast blocks dropped.